70/30 E Liquid Range

If you see an e liquid called a 70/30 then it means the ratio is 70% vegetable glycerin (VG): 30% propylene glycol (PG). The higher proportion of VG means it’s thicker and smoother, so it’s great for higher-powered devices that create large amounts of vapour.

70/30 Vape Juice is made from 70% VG (Vegetable Glycerine) / 30% PG (Propylene Glycol), ideal for Sub-Ohm vapers and Cloud Chasers alike. These E Liquids were designed specifically to create large clouds of vapour when exhaled, hence the term ‘Cloud chaser’. The High VG content makes these E Liquids much thicker than their 50/50 E Liquid or High PG cousins and, as such, are not recommended to use in anything but a Sub-Ohm device. Using 70/70 E Liquids with coils above 1ohm (such as those found in POD Systems, Vape Pens and Starter Kits) could lead to clogged coils that burn out much faster than usual.

A lot of seasoned vapers will opt for a 70/30 ratio for their vape juice. This is because it delivers a smoother inhale with a little bite, and big vape clouds on exhale. Hardcore vapers often like the vape cloud as part of their vaping experience and so opt for a 70/30 liquid over 50/50 where you get less of this effect.

As mentioned above if you are going to choose a 70/30 e-liquid then you need to make sure you have the device best suited to vaping one. Vaping 70/30 in an unsuitable device will cause clogging and burn out.

Shop our Hardware section and choose from one of our Sub Ohm options and you will be about to vape our 70/30 range with no issues.

Regardless of which type of e liquid you’re using, the ideal wattage to vape at may be different. That’s because optimum wattage depends more on the coil you’re using than the juice you’re vaping. The manufacturer of your device will usually tell you what wattage to vape at and this will be different depending on the device you’re using, so it’s always best to check the instructions.

When it comes to vaping 70/30 e liquid, we would always recommend using a device with a coil below 1-ohm. That’s because the lower resistance allows more heat to pass through the coil, which is needed to properly vaporise the more viscous VG.

Although mouth-to-lung (MTL) vaping is more suitable for plus-ohm devices that are best paired with 50/50 e liquid, there’s nothing to stop you from using this technique with 70/30 e liquid/ a sub-ohm kit.